Page 1 of 1
A little question
Posted: Sun May 07, 2006 9:50 pm
by XSephirotX
what is the best sincronisation in the CONFIG
# This is setting of experimental Client <--> Server Player coordinates synchronization,
# 0 - no synchronization at all
# 1 - parcial synchronization Client --> Server only * using this option it is difficult for players to bypass obstacles
# 2 - parcial synchronization Server --> Client only
# 3 - full synchronization Client <--> Server
# -1 - Old system: will synchronize Z only
CoordSynchronize = ???
Posted: Mon May 08, 2006 1:39 am
by xicoloco
here is note the forum to ask ... but depends in what you want to happen to your server each option ...
Posted: Fri May 12, 2006 10:39 pm
by DrLecter
it seems like value 1 works well enough, without lagging the server like 3. but needs more testing tho.
Posted: Fri May 12, 2006 11:33 pm
by XSephirotX
so , use 1 => parcial synchronization Client --> Server only * using this option it is difficult for players to bypass obstacles ?
but whit the 3 =>full synchronization Client <--> Server . Reduce lag?
Posted: Sat May 13, 2006 7:16 am
by slyce
I have tested all options for about one day:
0 - DON'T USE THIS!
1 - works well. only a few sync problems (we use it)
2 - player teleports around a lot while running and aggro is totally messed up
3 - good sync. somtimes player teleports while running. takes a lot of resources so it creates lags (you have to test if your server has more problems with sync or with lag)
-1 - everyone knows it *g*
in conclusion I would recommend using -1, 1 or 3 depending on the computer you are running the server on.
Posted: Sun May 14, 2006 2:13 am
by XSephirotX
My PC is....
"Pentium" "4" 2.8 buss 800, 3gbs ram, gforce 4 128. bla bla bla bla.
I wish 0 lag.
What is your recomendation for my? -1, 1 or 3
P.D: increase the conección: Those that uses Windows XP , the XP reserv 20% of coneccion, for which they have a single PC this does not serve to them. So that they have 100% of coneccion is following it:
1- "Beginning-Execute" and "writes gpedit.msc" and presses "Enter" (Aparecerá el editor de directivas de grupo en la izquierda)
2- "Configuration of the equipment" - "administrative groups" - "network", in the windows of the right beam click on "Programmer of QoS package" and soon in "limiting reserved bandwidth".
3- In the "configuration" eyelash it selects Qualified. In the pull-down menu it "limits of bandwidth writes 0". We accepted and already we will be taking advantage of all our bandwidth.